Welcome Guest, you are in: <root>Circuit IdeasColour MaxiMite 2 (CMM2)GCBMicroMite ArmMite and MMX HardwareMMBasicPIC ASMPlatform Agnostic • Login

Page History: Dual Function Push Button

Compare Page Revisions

4 3 2 1 0 Current 4 3 2 1 0

« Older Revision - Back to Page History - Newer Revision »

Page Revision: 2019/01/02 06:29

Introduction:
Sometimes, either to save space, I/O pins or hardware it may be desirable to use a single pushbutton for multiple uses. This routine allows the pushbutton to be used for two functions. A short press will execute one subroutine while a longer press will execute a second subroutine. While this arrangement could be extended to more than two functions that may become a bit unwieldy unless it was an extra long push, say 10 seconds for a reset.

The routine below uses the pushbutton to generate interrupts, one when the switch is operated (input low) and one when the switch is released. The timer is used to measure the length of the switch operation. Less than 2 seconds is a short press while greater than 2 seconds is a long press. A very short operation (<100mS) is considered to be contact bounce and is ignored.

An internal pull up resistor is used but if the switch is mounted away from the board then either an extra 10k pull up resistor should be used and/or a 100nF (.001uF) connected across the switch contacts.

Assumptions:
The switch is wired to connect the input pin to zero volts when operated (logic 0).

Acknowledgement:
The original code was by TassyJim on The Back Shed Forum

' Dual Function Push Button
' Original code by:
' Tassyjim on The Back Shed Forum
'
DIM integer bt
dim integer SwPin = 14 ' Pin number for the push button input

SETPIN SwPin,INTB,subB,PULLUP
  
DO
' Main program goes here
  IF bt = 1 THEN sub1
  IF bt = 2 THEN sub2
LOOP

SUB subB
  STATIC integer buttontimer
  LOCAL integer b
  IF PIN(SwPin) = 0 THEN ' button down
    buttontimer = TIMER
  ELSE  'button up
    b = TIMER - buttontimer ' this is how long the button was down
    IF b < 100 THEN ' too short, must be contact bounce
      bt = 0'do nothing
    ELSEIF b < 2000 THEN ' short press
      bt = 1 ' call first sub
    ELSE ' longer than ~two seconds
      bt = 2 ' call second sub
    ENDIF
  ENDIF
END SUB

SUB sub1
  PRINT "Switch on for less than 2 seconds"
  ' Funtion 1 code goes here
  bt = 0
END SUB

SUB sub2
  PRINT "Switch on for more than 2 seconds"
  ' Function 2 code goes here
  bt = 0
END SUB